Nemek 300TSE drilling rig

running hours: There is no hour meter on the machine, so it is uncertain
Specifications
In 2021
a lot of hydraulic hoses were changed
Engine oil
filter
hyd. filter
diesel filter and air filter as well as oil on track gears and rotary gearbox have recently been changed
Feed length for 3m lining pipes
Board up to 220mm
Cavotec radio control
Top winch 750kg
Rear mounted winch
Near stop cord on mast
Telescopic magazine for drill pipes above the left belt (120m)
Dynaset welding device
Dynaset water pump
Has been driven with a top hammer/Drifter by Tautech
Went with clamping table instead of key table at Tautech (Possibly still available at Qmatec if it is of interest)
Description
Light and clever rig that works as it should
even if it is getting a few years old. Very good technical condition
This is one of the last 300 models built at Nemek
Strong mast on this
the same as was used on the 510TS
Tautech rebuilt this machine from hydraulic levers to radio control
supplied by Cavotec
This is a rig for drilling casings and rock holes with a DTH hammer
It's an air-powered hammer
you have to have a large air compressor with you in addition to this
This is for drilling water wells or light foundations of smaller dimensions. It does not come with either a compressor
drill hammers
drill strings or air hoses